RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Community
Search
Notices
Search: Posts Made By: RBean
Showing results 1 to 12 of 12
Search took 0.01 seconds.
10-28-2020, 05:56 AM
Replies: 529
Views: 110,986
Posted By RBean

The plane flies good with the DLE 61 with the...

The plane flies good with the DLE 61 with the 22-10 two blade. Enough speed and good vertical. No complaints. It tunes out ok. I don't have a DLE 55RA so can't compare. I do have a DLE 55 with a pits...
10-27-2020, 06:54 PM
Replies: 529
Views: 110,986
Posted By RBean

I almost lost the Hellcat two weeks ago. Take off...

I almost lost the Hellcat two weeks ago. Take off was ok, then doing a circuit turning from down wind, the plane jerked. I didn't thank there were enough wind to cause that. Then while turning at the...
08-11-2020, 11:29 AM
Replies: 529
Views: 110,986
Posted By RBean

Finally got the Hellcat out to the flying field....

Finally got the Hellcat out to the flying field. Started ok then on take off the engine quit just off the ground. Landed three point. Turns out the clunk line had come off. I got this used and...
07-12-2020, 06:29 AM
Replies: 529
Views: 110,986
Posted By RBean

MaJ. Woody and others here who have flown this...

MaJ. Woody and others here who have flown this plane, our field is open and I am getting the Hellcat ready for a maiden. Charged up all the batteries and changed out the prop to a two blade 22-10,...
04-25-2020, 09:32 AM
Replies: 529
Views: 110,986
Posted By RBean

MaJ Woody, I see you have added the small front...

MaJ Woody, I see you have added the small front gear doors. Can you post pictures of how you did this. I would like to add some to my Hellcat. Thanks.
04-07-2020, 10:01 AM
Replies: 529
Views: 110,986
Posted By RBean

No, just the 1/4" bolt. The plane has already...

No, just the 1/4" bolt. The plane has already flown many times in that configuration without problems.
03-29-2020, 05:03 PM
Replies: 529
Views: 110,986
Posted By RBean

Capt...

Capt John,https://cimg6.ibsrv.net/gimg/www.rcuniverse.com-vbulletin/2000x1333/2003_01_14_10_13_08_c3d8d9e7814d1280315bd77f85b4fc506ba7ed23.jpgm

The flap joiner is installed in the inner flap....
03-28-2020, 03:01 PM
Replies: 529
Views: 110,986
Posted By RBean

The controls in the Hellcat I purchased used seem...

The controls in the Hellcat I purchased used seem to move without binding. I'm glad of that. It is all ready to go. Didn't get to fly it before the "lock down," so don't know when it will be. I...
03-07-2020, 06:38 PM
Replies: 529
Views: 110,986
Posted By RBean

Thanks for the info Planejaw. I have Robart...

Thanks for the info Planejaw. I have Robart electric gear in an H9 Mustang with a DLE 55. I've been using a Life 2S 6.6 volt battery for the gear. Seems to be working ok. About 20 flights on it. If a...
03-07-2020, 11:39 AM
Replies: 529
Views: 110,986
Posted By RBean

I just got a Top Flite Hellcat. Purchases used,...

I just got a Top Flite Hellcat. Purchases used, but looks to be in good condition. I rewired and changed control set up for my seven channel radio. Has a DLE 61 that started and ran ok. It has Robart...
09-01-2019, 04:33 AM
Replies: 529
Views: 110,986
Posted By RBean

Same can happen to any of us. I had a ESM...

Same can happen to any of us. I had a ESM Hurricane. It was always a PITA to land. I was flying when the cross wind got worse. It had a high wing loading. Touched down on the mains, just a small...
01-07-2018, 10:05 AM
Replies: 529
Views: 110,986
Posted By RBean

This is VERY BAD. I have alway been a Hellcat fan...

This is VERY BAD. I have alway been a Hellcat fan and have no room in the hanger for additions. It looks like I will have to make room.
Showing results 1 to 12 of 12


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.